GIS-K7
This guide will walk you through the initial installation and connection to your Guest Internet unit so that you can connect to the admin interface.
The back of your GIS-K7 unit:
The necessary cables to setup your unit:
Connection Steps
- Connect an Ethernet cable on the WAN port to your router
- Power on the GIS-K7 by connecting the power supply provided
- Wait 30 seconds for the GIS unit to complete the boot process
- Connect an Ethernet cable on the LAN port and connect the other end to your computer
- Open your browser at https://aplogin.com/admin
- The next step to configure your GIS unit is to follow the wizard available here
If you run into any issue with the installation of your unit please contact us. q If you need to Reset to Factory Defaults please click here
